Weidmuller PT 100/4 signal conditioners for current output Bedienungsanleitung PDF herunterladen (Seite 2)

1 General instructions

The W AVESERIES signal conditioner PT 100 should only be in-

stalled by qualified staff. The signal conditioner PT 100 should

only be powered up following professional installation.

2 Application

The WAVESERIES signal conditioner PT 100 can be used to

connect PT 100 sensors as well as converting temperature data

into standard linear current signals. The temperature range can be

set by DIP switches on the printed circuit board.

The signal conditioner PT 100/4 can be connected to 2-, 3- and

4-wir e temperature sensors.

3 Mounting and dismounting

Warning!! Mounting and dismounting may only be carried out

when the power supply has be disconnected. Failure

to observe will lead to considerable damage!

3.1 Mounting onto TS 35 DIN rails

(Figure 1)

1 2 3 4 5 6 7 ... 17 18

Keine Kommentare

Weidmuller PT 100/4 signal conditioners for current output Bedienungsanleitung Seite 2